A calibration by Custom-Cal is performed by engineers with extensive OEM experience. We have the expertise and the necessary standards to perform the ILX LIGHTWAVE TCM-39034 Calibration, onsite calibration may be available. We specialize in quick turnaround times and we can handle expedited deliveries upon request.

Need another Laser Diode Controller?
Shop for Comparable Products on our
 used Laser Diode Controller page

   ILX LIGHTWAVE TCM-39034 (39034)   Description / Specification:    
ILX LIGHTWAVE TCM-39034 32W TEC Module with Voltage Measurement

The ILX Lightwave TCM-39034 TEC module controls temperature of devices with 32W of power with Voltage Measurement. This TEC module offers maximum flexibility with a choice of operating modes and temperature sensors covering thermistors, IC, and RTDs. A low noise, bipolar output with TE voltage measurement and an ultra-stable topology achieves stabilities better than 0.005°C. A smart integrator control loop, programmable from the front panel or through GPIB, delivers fast settling times.

Temperature Control Output.
Temperature Control Range: -99 to 199.9° C.
Temperature Setpoint Resolution: 0.1° C (-20°C to 20°C), 0.2° C (20°C to 50°C).
Temperature Setpoint Accuracy: ±0.2° C.
Short-Term Stability (1 hr): ±0.004° C.
Long-Term Stability (24 hr): ±0.01° C.

TEC Output.
Type: Bipolar current source.
Isolation: Isolated from other modules and earth ground.
Control Algorithm Smart Integrator, Hybrid PI.
Compliance Voltage: >8 V.
Short Circuit Output Current: 4A.
Maximum Output Power: 32W.
Current Noise and Ripple: <1 mA rms.


Related Optical Terms and Definitions. For a complete list go to our  Terms and Definitions Page.

Bit Error Ratio (BER)
Bit Error Ratio (BER) is the ratio of errors caused by the number of bits in a data stream that have been altered due to noise, interference, distoriton or bit synchronization errors.

Variation of insertion loss on the passband of an optical device.

Polarization Dependent Loss (PDL)
Polarization Dependent Loss is the difference between the maximum and minimum values of loss due to the variation of the polarization states of light propagating through a device. PDL is expressed in decibels. Calculated by; PDL = 10 log10 (Ep/Es), where EP and ES are the measured diffraction efficiencies for P- and S-plane polarized incident light, respectively.

Return Loss (RL)
Return Loss (RL) is the ratio of the incident power to the reflected power expressed in dB. RL = 10log (Pin/Pback)

Wavelength Resolution
Wavelength Resolution is the smallest possible displayed wavelength increment/decrement.

Please contact us for your ILX LIGHTWAVE TCM-39034 CALIBRATION and/or ILX LIGHTWAVE TCM-39034 32W TEC Module with Voltage Measurement REPAIR

I'm interested in: 
Calibration Type (Select one):

Repair Information:
 Serial Number:

 Is there any physical damage?  
 If yes, describe:

What is the description of the problem?

How/when did the problem start?

 (*) Required Fields    For formal quote please fill in all fields.
From (Email):*
Contact Name:*
Address 1:
Address 2:
State/Territory/Province: *
Zip/Postal Code: