KEYSIGHT N5239B CALIBRATION and KEYSIGHT N5239B REPAIR
 
A calibration by Custom-Cal is performed by engineers with extensive OEM experience. We have the expertise and the necessary standards to perform the KEYSIGHT N5239B Calibration, onsite calibration may be available. We specialize in quick turnaround times and we can handle expedited deliveries upon request.

Need another Network Analyzer, SNA, VNA?
Shop for Comparable Products on our  used Network Analyzer, SNA, VNA page or new Network Analyzer, SNA, VNA page

 
   KEYSIGHT N5239B   Description / Specification:    
KEYSIGHT N5239B 8.5 GHz PNA-L Microwave Network Analyzer

The Keysight N5239B PNA-L Microwave Network Analyzer, 300 kHz to 8.5 GHz, 2-ports with a single built-in source. It can perform basic analysis of passive components and simple active devices. Measure S-parameters with good accuracy up to 8.5 GHz.
Specifications.

Maximum System Dynamic Range: 144 dB.
Maximum Receiver Dynamic Range: 134 dB.
Test Ports: 3.5 mm (male), 50 ohm (nominal), 0.002 in. Center Pin Recession (characteristic).

Test Port Output.
Frequency Range: 300 kHz to 8.5 GHz.
Frequency Resolution: 1 Hz.
Frequency Accuracy: +/- 1 ppm.
Frequency Stability Typical: +/-0.05 ppm, -10° to 70° C.
Maximum Leveled Power: 13 dBm.

Test Port Input.
Maximum Test Port Noise Floor: -120 dBm.
Maximum Direct Receiver Access Input Noise Floor: -133 dBm.

Hardware options.
N5239B-200  2-port base hardware configuration.
N5239B-216  2-port, configurable test set, source attenuators.

Software Options with Subscription.
S93007B  Automatic fixture removal.
S93010B  Time-domain analysis.
S93011B  Enhanced time domain analysis with TDR.
S93080B  Frequency-offset measurements.
S93082B  Scalar mixer/converter measurements.
S94601B  Device measurement eXpert - DMX.
S94602B  Limit assistant.
S930900B  Spectrum analysis up to 8.5 GHz.
S93551B  N-port measurements.
S93898B  Built-in performance test software.



 



Related RF Terms and Definitions. For a complete list go to our  Terms and Definitions Page.

Adjacent Channel Power
Adjacent Channel Power is the power from a modulated communications channel that leaks into an adjacent channel. This leakage is usually specified as a ratio to the power in the main channel, but is sometimes an absolute power.

Fall Time
Fall time is the time required for the amplitude of a pulse to decrease (fall) from a specified value (usually 90 percent of the peak value exclusive of overshoot or undershoot) to another specified value (usually 10 percent of the maximum value exclusive of overshoot or undershoot).

Overshoot
Overshoot is the distortion that follows a major transition; the difference between the peak power point and the pulse-top amplitude computed as a percentage of the pulse-top amplitude.

Please contact us for your KEYSIGHT N5239B CALIBRATION and/or KEYSIGHT N5239B 8.5 GHz PNA-L Microwave Network Analyzer REPAIR
I'm interested in: 
Calibration Type (Select one):
Repair Information:
 Serial Number:

 Is there any physical damage?  
 If yes, describe:


What is the description of the problem?

How/when did the problem start?


 (*) Required Fields    For formal quote please fill in all fields.
Company:
From (Email):*
Contact Name:*
Country:*
Address 1:
Address 2:
City:
State/Territory/Province: *
Zip/Postal Code:
Phone:*

Comment: