|
|
The HP 6205C Dual Output Dual Range DC Power Supply is equipped with ten-turn output voltage controls, volt/ampere meter, meter function/ range switch, and front and rear output termina ls. In addition, an output range switch permits the selection of either a high or a low output voltage range. Model 6205C combines the versatility of a dual power supply with the flexibility of auto-parallel and auto-series operation to extend the output ratings of this supply to 20 V / 1.2 A, 40 V /0.6 A, and 80 V / 0.3 A. In addition, using the supply's auto-tracking capability, opposite polarity voltages (±20 V, ±40 V) can conveniently be obtained from this one supply. This constant voltage/current limiting supply is short-circuit protected by a fixed current limiting circuit which is activated at approximately 110% of rated load current. The current-limit point can be reduced by changing the value of a single internal resistor. Units may be bench operated or rack mounted individually or in pairs using accessory rack mounting hardware. DC Output; 0-20/0-40 and 0-20/0-40 V, 0-0.6/0.3 and 0-0.6/0.3. Load effect: 0.01% + 4 mV. Source effect: 0.01% +4 mV. PARD rms/ p-p: 200 uV/ 1 mV. Control Mode and Resolution: CV/CL, 10 mV. Remote Control Coefficients: 200 ohm/V ±1%. Options. Opt 011: internal overvoltage protection crowbar. Protects delicate loads against power supply failure or operator error. Opt 028: 230 Vac ± 10%, single phase input. Consists of reconnecting power transformer taps, and other components where necessary. Opt 040: Multiprogrammer interface, Prepares HP 6205C power supplies for resistance programming by the HP 6940B or 6942A Multiprogrammer.
|