Custom-Cal has a high success rate in the repair of the ANRITSU 560-7K50. A calibration by Custom-Cal is performed by engineers with extensive OEM experience. We have the expertise and the necessary standards to perform the ANRITSU 560-7K50 Calibration, onsite calibration may be available. We specialize in quick turnaround times and we can handle expedited deliveries upon request.

Need another RF Power Sensor?
Shop for Comparable Products on our
 used RF Power Sensor page

   ANRITSU 560-7K50   Description / Specification:    
ANRITSU 560-7K50 40 GHz RF Detector

The Anritzu 560-7K50 RF detector is used with the Model 56100A and 562 Scalar Network Analyzers and with Series 541XXA, 540XXA, and 54XXA Scalar Measurement Systems for making coaxial transmission loss or gain and power measurements. The detector is also used with the Site Master and Cable Mate Series Personal SWR/RL and Fault Location Testers for making power measurements. The center pin of the RF component connector has a precision tolerance measured in mils (1/1000 inch). Specifications. Frequency Range: 0.01 to 40 GHz. Impedance: 50 ohms. Return Loss: 12 dB <0.04 GHz, 22 dB <8 GHz, 17 dB <18 GHz, 15 dB <26.5 GHz, 14 dB <32 GHz, 13 dB <40 GHz. Input Connector: K(m). Frequency Response: ±0.5 dB <18 GHz, ±1.25 dB <26.5 GHz, ±2.2 dB <32 GHz, ±2.5 dB <40 GHz. Maximum Input Power: 100mW (+20 dBm).


Standard Calibration $260.00 *
Click on Logo for More Prices
*This is a Web introductory price for one calibration of the ANRITSU 560-7K50. Price does not in most cases include measurement performance data. Pricing does include NIST traceable calibration and issue of a calibration certificate and calibration label. Pricing may vary slightly due to volume and location of laboratory supporting calibration. Volume pricing may apply. On-site fees may apply depending on logistics, location and volume of work to be completed during the visit.

Related RF Terms and Definitions. For a complete list go to our  Terms and Definitions Page.

dBm (sometimes dBmW) is an abbreviation for the power ratio in decibels (dB) of the measured power referenced to one milliwatt (mW). Zero dBm equals one milliwatt. A 3 dB increase represents roughly doubling the power, a 3 dB decrease, the power is reduced by about one half.

Noise Figure
Noise Figure the ratio of the signal-to-noise power ratio at the input to the signal-to-noise power ratio at the output.

Standing Wave Ratio (SWR)
Standing wave ratio (SWR) is the ratio of the amplitude of a partial standing wave at an antinode (maximum) to the amplitude at an adjacent node (minimum).

Please contact us for your ANRITSU 560-7K50 REPAIR and/or ANRITSU 560-7K50 40 GHz RF Detector CALIBRATION

I'm interested in: 
Calibration Type (Select one):

Repair Information:
 Serial Number:

 Is there any physical damage?  
 If yes, describe:

What is the description of the problem?

How/when did the problem start?

 (*) Required Fields    For formal quote please fill in all fields.
From (Email):*
Contact Name:*
Address 1:
Address 2:
State/Territory/Province: *
Zip/Postal Code: